Powered by Amazon WebStore, an Amazon Services ProductVisit Amazon.com
 

Search
Go

Shop by category
 
 
The MA-Line MA-FB2 HUB PULLER
Email a friendView larger image

The MA-Line MA-FB2 HUB PULLER

SKU:

MA-FB2

This product is currently out of stock
Product Details:
Average Customer Rating: based on 2 reviews
You may also like ...
Customer Reviews:
Average Customer Review: 3.5 ( 2 customer reviews )
Write an online review and share your thoughts with other customers.


Most Helpful Customer Reviews

2 of 2 found the following review helpful:

3From the photo this is exactly the same as SUPCO FBP100Mar 22, 2011
By Hobbyist "Chemistry for fun, Computers for money."
I already own the ULTIMATE HUB FAN BLADE BLOWER WHEEL PULLER reviewed elsewhere on Amazon.com. The SUPCO FBP100 is identical to the MA-FB2 puller here. I bought the SUPCO FBP100 to have another puller available since I have two tool bags that I carry in different vehicles. The differences are clear and the SUPCO FBP100 falls short. The SUPCO FBP100 has threaded holes that are not precisely aligned to the center of the tool. The supplied bolts, both square head and cap screw, are coated steel and have a good bit of roughness to be worked out... I could not insert them fully by hand and had to resort to the supplied Allen wrench just to get them to go through the holes. The main bolt was no better and will require grease or dripless oil to function. The hooks are very heavy, much more than the ones with my other puller, and that may not be a fault by itself. But the holes supplied for the hooks do not allow using 3 hooks in any symmetry that will work with a 3-blade fan. There are only 4 holes and they are clearly for use with 2 or 4 hooks only. The tool relies on a plastic tube for alignment of the motor shaft to the puller shaft. The instructions also recommend using a center punch to indent the motor shaft end to match the pin point on the puller shaft. This is a far cry from the other puller I mentioned, where the motor shaft goes into the recessed neck of the puller in an area that is not threaded -- keeping the shafts aligned with no effort on your part. In fact, I never thought about the alignment issue with the other tool. I expect I'll get good service from the new SUPCO FBP100 tool. But when you have a choice, choose quality over price because there's a big difference.

1 of 1 found the following review helpful:

4FAN BLADE PULLERJun 08, 2010
By William T. Harvey Jr. "Audime"
Fan puller did the job - however, the quality control of the product could have been better. The center bolt was not aligned (centered) properly.

About Us   Contact Us
Privacy Policy
Web business powered by Amazon WebStore
Web business powered by Amazon WebStore